GERMAN MINE WARFARE EQUIPMENT |
PART TWO – GERMAN MINE WARFARE EQUIPMENT |
CHAPTER 7 - ANTIPERSONNEL MINES |
Section III. ANTILIFTING DEVICES AND BOOBY TRAPS |
113. Wooden Antilifting Device (Entlastungsmine) |
a. Description. The wooden antilifting device (fig. 140) consists of a wooden case, about 6 1/4 inches long, 4 3/4 inches wide, and 2 1/4 inches high. The wooden case contains a 0.5-pound main charge and a pull fuze 42 (par. 42). A wooden block is located at the end opposite the main charge and has a hole drilled part of the way through the center of its upper side. A strong actuating spring fits in this hole and projects above the top edge of the wooden case. The hinged lid has a small arming hole located directly above the striker-retaining pin of the pull fuze 42, and a spring recess directly over the actuat-ing spring. The hinged lid is held shut with an inprovised latch, compressing the actuating spring. An actuating wire attached to the striker- retaining pin of the pull fuze 42 is threaded through the arming hole in the lid and tied to a nail lying across the arming hole. |
b. Employment. This antilifting device is used to activate mines and may be used as a booby trap. |
c. Funtioning. When the weight is lifted from the wooden case, the compressed actuat-ing spring forces the hinged lid up. At the same time the actuating wire pulls the striker-retaining pin out of the striker shaft, releasing the spring-loaded striker against the per-cussion cap and firing the antilifting device. |
d. Installing and Arming. |
(1) |
Screw a pull fuze 42, with detonator into the main charge. |
(2) |
Tie an actuating wire to the striker-retaining pin of the pull fuze 42 and thread it through the arming hole. |
(3) |
Close the hinged lid and fasten it with the improvised latch. |
(4) |
Tie the actuating wire to a nail lying across the arming hole. Be careful not to pull on the actuating wire so as to pull out the striker-retaining pin. |
(5) |
Place the antilifting device in a hole and place a mine or charge on top of it. |
Caution: Be certain the mine or charge is heavy enough to hold the hinged lid down against the force of the compressed actuating spring. |
|
(6) |
Carefully disengage the improvised latch on the hinged lid. |
e. Neutralizing. |
(1) |
Secure the hinged lid tightly with the improvised latch. |
(2) |
From a distance of 50 yards, pull the mine form the hole with a rope or wire. |
(3) |
Cut or untie the actuating wire attached to the striker-retaining pin of the pull fuze 42. |
(4) |
Carefully raise the hinged lid. |
(5) |
Unscrew the fuze and remove the detonator from it. |
Figure 140. Wooden antilifting device. |
|
|